Get a quote

Home / Resources / Steel vs aluminium solar carports

Steel vs aluminium solar carports

Hot-dip galvanized steel, Zn-Al-Mg steel or aluminium? Compare strength, corrosion, weight, cost and where each material fits.

Steel vs aluminium solar carports

The short answer

For commercial car parks, hot-dip galvanized steel is usually the most economical choice. Aluminium suits homes, small carports, waterproof roofs and coastal sites where low weight and corrosion resistance matter more than material cost. Zn-Al-Mg coated steel sits between the two and is common for purlins and rails.

Comparison

Hot-dip galvanized steelZn-Al-Mg coated steelAluminium AL6005-T5
StrengthHigh (S355 / Q355); best for long spans and heavy loadsHigh; mostly thin cold-formed sectionsLower stiffness; needs deeper sections for the same span
CorrosionGood; zinc layer 65–85 µmVery good; cut edges self-healExcellent; no coating needed
WeightHeaviestMediumAbout one third of steel
Material costLowest per kWp for large projectsLow to mediumHighest
Typical useCommercial, multi-bay, truck and bus canopiesPurlins, rails, humid sitesResidential kits, waterproof and coastal projects

When steel is the better choice

  • Large car parks where cost per kWp drives the decision
  • High wind or heavy snow, and spans above about 6 m
  • High-clearance canopies for trucks and buses

When aluminium is the better choice

  • Homes and small carports installed by small crews without cranes
  • Coastal and industrial sites with aggressive air
  • Waterproof roofs, where aluminium gutter rails and profiles fit together well

Mixing materials

Many projects combine them: galvanized steel columns and beams, with Zn-Al-Mg or aluminium rails. Use stainless steel or coated fasteners and isolating washers where aluminium touches steel, to avoid galvanic corrosion.

Not sure which fits your site? Send us the location and layout and we will propose the material with the structure.

Coating thickness and life

Hot-dip galvanizing protects steel by sacrificing zinc slowly. In mild inland air, a 70–85 µm zinc layer can last decades; in coastal or industrial air the loss is faster. Zn-Al-Mg coatings lose less coating per year and protect cut edges. Aluminium forms its own oxide layer and needs no coating, though anodizing improves appearance.

Weight and installation

Aluminium parts weigh about one third of steel, so small crews can handle them without cranes. That is why residential kits are usually aluminium. Large commercial bays with long spans still favour steel because of stiffness and cost.

Recycling

Both steel and aluminium are fully recyclable at end of life, and both have established scrap markets worldwide.

Get a quote

Tell us about your car park

Send the number of spaces and the site location. We reply with a layout, structure proposal and price, usually within one working day.